0

Score

Avatar
Richard A
1

Asked

Printrbot does not communicate with computer WIN-PC

History

This question is archived. No new answers are allowed, and only the question's owner may edit it.

Pronterface software does not CONNECT to printrbot.

USB driver was installed successfully. Power supply works, LED on board lights up, USB cable is connected.

Com ports are listed on pronterface software.

I tried this on four different computers, same result

for about six hours. This is a new printrbot plus printer.

Do you believe that the PC board is defective, wires

crossed? Do you have an actual wiring schematic drawing so that I can carefully check the connections?

I have done everything that I can think of. What are

your suggestions?

Thanks,

Richard Atcheson

Edited by: Ian Lewis ( )

Archived as not answerable by Ian Lewis

Add Comment Cancel

Post Answer

0

Score

Avatar
Nathaniel
275

Answered

PermalinkHistory

I had a similar problem 2 days ago, did you try switching between all available com#(s). and clicking connect after selecting each and every one? and of coarse waiting for the console to register it's verdict?

Also it might be helpful if you told us what console said after each attempt to connect.

Archived as not answerable by Ian Lewis

Add Comment Cancel

0

Score

Avatar
satovey
151

Answered

PermalinkHistory

Is the Printrbot listed in Devices and Printers?

I removed my board from underneath the bed and installed it into a separate container. When installing into the new case, I decided to put the screws in upside down to make it easier to install the board into it's new case.

The good news is that it was easier to install the board.

The bad news is that the computer no longer picked up the Printrbot.

Check the corners where the bolts are inserted, if there are any washers, remove them they don't belong there and they will cause a short giving you this exact symptom.

Archived as not answerable by Ian Lewis

Add Comment Cancel

0

Score

Avatar
Attley
1

Answered

PermalinkHistory

I had the same problem.

Somewhere I had seen something about running as administrator.

I'm not sure if this is what fixed the problem but when I did it Pronterface

came alive and I had a valid intrerface. Under windows 7:

1) Go to 'Start'

2) Search for 'Serial Install'

3) Right click on 'Serial Install'

4) Select 'Properties from drop down screen

5) Select 'Compatabilty' tab

6) Under 'Privilege level' check the"Run this program as administrator" box

7) Select 'Serial Install' file and run it.

Hope this does it for you.

Attley

Archived as not answerable by Ian Lewis

Add Comment Cancel

Add Your Answer

View Statistics:

Today: 1

This Week: 2

This Month: 6

All Time: 771